Advertisement
3. Loosen set screws on wired terminals labeled
REMOTE and insert wires into the openings. Tighten
set screws. (See following figure for switch connection)
4. Connect wires at door switch.
Jumper Placement
Description
BATTERY POWERED
NOTE: For battery powered, the 2 jumpers must be
positioned on the center and left pins. See jumper pin location
in photo above.
POWERED CONNECTION
NOTE: For external power connection, the 2 jumpers must
be positioned on the center and right pins. See jumper
location in photo above.
Jumper in position
for external power
External Power
Connections
Wired Door Switch
Connections
Mounting Sensor/Door Magnet Installation
for DD01E and DD01F Kits
DD01E and DD01F must be mounted on the top door frame
as close to the door as possible in the horizontal position.
A DT01* must be installed in the PTAC unit for the DD01E
or DD01F to be operable.
Skip these steps if not installing.
1. Remove motion sensor from mounting plate by pulling
apart.
2. Mount the back plate on the door trim directly above
the door using the enclosed screws. (Position so the
UP arrow is pointing up.) Mount the DD01E as low as
possible on the door frame to be as close to the moving
part of the door as possible without interfering with
the door opening or closing. Choose a location for
mounting the back plate that will provide good coverage
of the PIR for motion into the room. Make sure that
the DD01E will not interfere with the normal opening
and closing of the door.
DO NOT SNAP MOTION SENSOR IN PLACE UNTIL AFTER
BINDING PROCESS.
See Binding Instructions, page 10.
DOOR TRIM
DD01E and DD01F Mounting
3. Install two (2) AA batteries (included) into the back of
the sensor. Terminals are marked "+" and "-" for
polarity. Do NOT put batteries into the device until
AFTER the magnet location is selected to test.
4
DD01*
DOOR
Advertisement
