Advertisement
Setback Temps - DD01E / DD01F
The DD01* and the DigiSmart™ control can be programmed for 3 different times to activate temperature setbacks. The
current factory default temperature setbacks in v2.5 * software release are: 2º from set point in 30 minutes, 3º in one
(1) hour, and 6º in three (3) hours. For each time, you can select a setback temperature. The amount of setback is the
amount of degrees the control will operate from guest's setting in degrees F . If a change to the factory default temperature
settings is desired, use the following instructions.
NOTE:
When first entering the configuration mode, if you see " - - " then you have version 2.5 or higher.
You can verify the software version by starting with the unit in the OFF position, and while holding down the
"+" and "-" buttons , double click the COOL button and then release and push the FAN button within one
second. The unit display will scroll through all of the thermister temperatures and the last item displayed
will bs CS (current software) and you will see 25 for v2.5.
*Other software versions may have different factory setback defaults. Contact
determine factory default settings.
WARNING
4. To select first unoccupied set back temperature, press the HEAT
To scroll to a previously viewed feature codes, press the COOL
Once you have scrolled to the
unoccupied setback temperature. Cooling example: 72
tional set point).
5. Press HEAT
time between when the control determines that the room is not occupied and when the control sets the operating
set point temperature back. The increments are in hours (.1 = 6 mins., .5 = 30 mins., 1 = 1 hour, etc.). Press ei-
ther the up or down arrow
6. To select second unoccupied setback temperature, press the HEAT
the up or down arrow
Cooling example: 72
7. Press HEAT
to the desired second unoccupied setback time. Example: Operating set point would be 76
hour (1.0 hour) after guest leaves room.
8. Press HEAT
to the desired third unoccupied setback temperature.
feature, press either the up or down arrow
key to scroll to
first unoccupied setback time. The first unoccupied setback time is the
to the desired first unoccupied setback time. c
to the desired second unoccupied setback temperature.
0
0
(guest set point) + 4
(Setback temperature) = 76
key to scroll to
second unoccupied setback time. Press either the up or down arrow
key to scroll to
third unoccupied setback temperature. Press either the up or down arrow
key until
key.
0
(guest set point) + 2
0
(Setback temperature) = 74
key until
0
(operational set point).
13
your PTAC representative to
feature code comes up.
to scroll to the desired first
0
(opera-
comes up. Press either
0
0
instead of 72
, one
Advertisement
