Advertisement
1-INCH (25MM) DROP (BASE
BRACKET POSITIONED UP)
Mounting
Hook
Base Bracket
Mounting Hook Glides
DETAIL "A"
18 AND 20-INCH DROP
BASE
FIGURE 1 - ASSEMBLING/ADJUSTING DROP BASE, INSTALLING DROP BASE AND ADJUSTING DROP BASE
4. Perform one (1) of the following:
BASE BRACKETS NEED TO BE REPOSITIONED
UP AND/OR DOWN:
A. Remove the two (2) mounting screws that secure
one (1) of the base brackets to the drop base.
B. Rotate base bracket 180
C. Line up the mounting holes in the base bracket
with the mounting holes in the drop base.
D. Reinstall the two (2) mounting screws that secure
one (1) base bracket to the drop base and tighten
securely.
E. Repeat STEPS A-D for remaining base brackets.
F. Continue with STEP 5.
2-INCH (50MM) DROP (BASE
BRACKET POSITIONED UP)
Base
Bracket
Mounting Hook
Mounting Screws
Leg Cutout
Abductor Mounting Holes
ALL DEPTHS EXCEPT 18
AND 20-INCH
HEIGHT, WIDTH AND/OR ANGLE
o
. Refer to FIGURE 1.
BRACKET POSITIONED DOWN)
Base Bracket
Rotated 180
Hook and Loop Faces UP
TOWARDS FRONT
OF WHEELCHAIR
Base Bracket
Mounting Screws
BASE BRACKETS NEED TO BE REPOSITIONED
FORWARD AND/OR REARWARD:
A. Remove the two (2) mounting screws that secure
one (1) of the base brackets to the drop base.
B. Perform one (1) of the following (DETAIL "A" of
FIGURE 1):
ALL BASE BRACKETS EXCEPT 18 AND 20-
INCH FRONT BASE BRACKETS - Reposition
the base bracket to one (1) of two (2) positions.
18 AND 20-INCH FRONT BASE BRACKETS -
Reposition the base bracket to one (1) of three
(3) positions.
C. Line up the mounting holes in the base bracket
with the mounting holes in the drop base.
D. Reinstall the two (2) mounting screws that se-
cure one (1) base bracket to the drop base and
tighten securely.
2
FLUSH MOUNTING (BASE
o
TOWARDS REAR OF
WHEELCHAIR
Crossbrace
Cutout
Base Bracket - (Factory
Installed on Drop Base)
Advertisement
