Reversing Feet To Stakes - Evenflo 23012148 Manual

1
When using your enclosure outdoors on lawns or other soft surfaces, reverse the feet to stakes, as shown below in
step 2.
To reverse the feet to stakes, follow these steps.
Close the enclosure completely as shown in the "Folding for Transport or Storage" instructions (p. 4), and lay it on
its side, as shown.
Note: When using the enclosure outdoors on a hard
surface, DO NOT reverse the feet to stakes.
2
Push the release button
Turn the foot around and insert it into the same opening so the stake is pointing out, as shown. When the stake is
inserted completely, you will hear an audible click.
Repeat this with all remaining feet on the enclosure.
At this point you are ready to set up the enclosure outdoors on lawns or other soft surfaces where stakes can be inserted.
After enclosure is set up in a proper configuration (see previous page), push each stake into the ground to ensure the
enclosure is stable.
Note: When using the enclosure outdoors on a hard
surface, DO NOT reverse the feet to stakes.
Note: When using the enclosure indoors, use this
same process to reverse the stakes back to feet.
on one of the bottom hinges, then pull the foot out of the hinge.
D
D
CLICK!
3

Reversing Feet to Stakes