JVC GR-SXM76 Instructions Manual page 33

Focus detection zone
NOTES:
● If the lens is smeared or blurred, accurate
focusing is not possible. Keep the lens clean,
wiping with a piece of soft cloth if it gets
dirty. When condensation occurs, wipe with
a soft cloth or wait for it to dry naturally.
● When shooting a subject close to the lens,
zoom out first ( pg. 21). If zoomed in in
the auto focus mode, the camcorder could
automatically zoom out depending on the
distance between the camcorder and the
subject. This does not occur with "TELE
MACRO" ( pg. 27).
System
Select Switch
Select Wheel
NOTES:
● To return to Auto Focus, select "AUTO" in step 4.
● To re-adjust Manual Focus, repeat the procedure from step 2.
● Be sure to focus the lens in the maximum telephoto position when you use the Manual Focus mode. If you
focus in on a certain subject in the wide-angle position, sharply focused images cannot be obtained when
zoomed in because the depth-of-field is reduced at longer focal lengths.
● When the focus level cannot be adjusted any farther or closer, " " or "
Power Switch
Focusing
AUTO FOCUS
The camcorder's Full Range AF system offers continuous
shooting ability from close-up to infinity. However, correct
focus may not be obtainable in the situations listed below
(in these cases use manual focusing):
•When two subjects overlap in the same scene.
•When illumination is low.*
•When the subject has no contrast (difference in bright-
ness and darkness), such as a flat, one-colour wall, or a
clear, blue sky.*
•When a dark object is barely visible in the viewfinder.*
•When the scene contains minute patterns or identical
patterns that are regularly repeated.
•When the scene is affected by sunbeams or light
reflecting off the surface of a body of water.
•When shooting a scene with a high-contrast background.
* The low-contrast warning "
MANUAL FOCUS
If you are using the viewfinder, you should already have
made the necessary viewfinder adjustments (
1
Set the System Select Switch to "D.S.C." or "VIDEO",
and set the Power Switch to "PRO.".
2
Press the Select Wheel to display the Menu Screen.
3
Rotate the Select Wheel to move the highlight bar to
"FOCUS" and press it. The FOCUS Menu appears.
4
Rotate the Select Wheel to move the highlight bar to
"MANU", then press it. The Menu Screen disappears
and " " and " " appear. The focus is locked at this
point.
5
To focus on a farther subject, rotate the Select Wheel
upward. " " appears and blinks.
To focus on a nearer subject, rotate the Select Wheel
downward. " " appears and blinks.
6
Press the Select Wheel. The setting is complete. The
Menu Screen reappears with the highlight bar on
"RETURN".
7
Press the Select Wheel. The Menu Screen disppears
and " " reappears to indicate the focus is locked.
" will blink.
33
EN
" appears
pg. 13).