ENGLISH (Original instructions) SPECIFICATIONS Model XLT02 Standard bolt M4 - M12 (5/32 " - 1/2") Capacities High tensile bolt M4 - M8 (5/32 " - 5/16") Square drive 9.5 mm (3/8") No load speed (RPM) 0 - 2,000 /min Impacts per minute 0 - 3,000 Max.
Page 3
13. Remove any adjusting key or wrench before 25. Use power tools only with specifically turning the power tool on. A wrench or a key left designated battery packs. Use of any other attached to a rotating part of the power tool may battery packs may create a risk of injury and fire.
USD302-1 Tips for maintaining maximum battery life Symbols Charge battery cartridge before completely discharged. The followings show the symbols used for tool. Always stop tool operation and charge the ・ volts battery cartridge when you notice less tool power. ・ direct current Never recharge...
Page 5
(Lithium-ion battery with star marking) This tool is equipped with an electric blade brake. If the tool consistently fails to quickly stop blade after switch lever release, have tool serviced at a Makita service center. 1. Star marking Lighting up the front lamp...
Page 6
Adjusting the angle head ASSEMBLY The angle head can be adjusted 360°(8 positions in 45-degree increments). To adjust it, loosen the hex bolt CAUTION: and remove the angle head. Always be sure that the tool is switched off and the •...
OPERATION High tensile bolt (ft lbs) CAUTION: (29) Always insert the battery cartridge all the way until it • M8(5/16") locks in place. If you can see the red part on the (M8(5/16")) upper side of the button, it is not locked completely. (22) Insert it fully until the red part cannot be seen.
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Sockets • Extension bar • Universal joint •...