Cisco VIP-4R/4T Installation And Configuration Manual page 22

Versatile Interface Processor Functions
The show controllers cbus command displays the internal status of each interface processor,
including the slot location, the card hardware version, and the currently-running microcode version.
It also lists each interface (port) on each interface processor including the logical interface number,
interface type, physical (slot/port adapter/port) address, and hardware (station address) of each
interface. The following example shows a VIP, with serial interfaces, installed in interface processor
slot 3:
The show startup-config command displays the contents of the system configuration file stored in
NVRAM. This file should reflect all new configuration changes you made and wrote to memory
with the show running-config command. (A serial interface is used in this example.)
The show protocols command displays the global (system-wide) and interface-specific status of any
configured Level 3 protocol.
22 VIP-4R/4T Installation and Configuration
Router# show controller cbus
(display text omitted)
slot3: VIP, hw 2.1, sw 200.09, ccb 5800FF70, cmdq 480000A0, vps 8192
software loaded from system
FLASH ROM version 255.255, VPLD version 20.0
4T HW Revision 121, SW Revision 216, Unresponsive 0
Serial3/1/0, addr 0000.0ca5.2380 (bia 0000.0ca5.2380)
gfreeq 48000140, lfreeq 48000238 (1536 bytes), throttled 0
rxlo 4, rxhi 123, rxcurr 16, maxrxcurr 16
txq 48000240, txacc 480000EA (value 77), txlimit 77
Serial3/1/1, addr 0000.0ca5.238e (bia 0000.0ca5.238e)
gfreeq 48000140, lfreeq 48000238 (1536 bytes), throttled 0
rxlo 4, rxhi 123, rxcurr 16, maxrxcurr 16
txq 48000240, txacc 480000EA (value 77), txlimit 77
(display text omitted)
Router# show startup-config
Using 1652 out of 130048 bytes
version 11.1(1)
!
hostname Router
!
enable-password hello
!
microcode VIP flash VIP11-0
microcode reload
!
(display text omitted)
!
interface serial 3/1/0
ip address 1.1.1.1 255.255.255.248
ip route-cache cbus
!
(display text omitted)
Router# show protocols
Global values:
Internet Protocol routing is enabled
Serial3/1/0 is up, line protocol is up