Japanese Electric Appliance And Radio Laws; Statement 371-Power Cable And Ac Adapter - Cisco uBR7200 Regulatory Compliance And Safety Information Manual

Japanese Electric Appliance and Radio Laws

•
•
•
•
•
•
•
Japanese Electric Appliance and Radio Laws
When installing the product, please use the provided or designated connection cables/power cables/AC
adapters. Using any other cables/adapters could cause a malfunction or a fire. Electrical Appliance and
Material Safety Law prohibits the use of UL-certified cables (that have the "UL" shown on the code) for
any other electrical devices than products designated by CISCO. The use of cables that are certified by
Electrical Appliance and Material Safety Law (that have "PSE" shown on the code) is not limited to
CISCO-designated products.)
Statement 371—Power Cable and AC Adapter
Regulatory Compliance and Safety Information for the Cisco uBR7200 Series Universal Broadband Routers
88
The ports marked "Ethernet," "10BaseT," "TokenRing," "FDDI," "Console," and "AUX" are SELV
circuits. SELV circuits should only be connected to other SELV circuits.
Connection of AC power supply: the Cisco uBR7200 series is intended for use when supplied with
AC power from a power source providing 7A maximum at 100 VAC and 3.5A maximum at
240 VAC, 50/60 Hz, with the chassis fully configured.
Connection of DC power supply: the Cisco uBR7200 series is intended for use when supplied with
DC power from a power source providing 13A maximum at –48 VDC and 8A maximum at
–60 VDC, with the chassis fully configured.
Other usage will invalidate any approval given to this apparatus if as a result it ceases to comply with
EN60950:1992.
Except in Australia, the PA-2CE1, PA-8B-ST, PA-4E1G-75, and PA-4E1G-120 port adapters are
designated SELV within the scope of EN60950:1992. Users are reminded that ports on these port
adapters should only be connected to SELV ports on other equipment in accordance with EN60950
clause 2.3.
This customer equipment must be installed and maintained by service personnel as defined by
AS/NZ3260 clause 1.2.14.3 Service Personnel. Incorrect connection of equipment to the General
Purpose Outlet could result in a hazardous situation.
Safety requirements are not fulfilled unless the equipment is connected to a wall socket outlet with
protective earth ground.
78-14140-08