VIBIA Swing Assembly Instructions

CAUTION : TO AVOID POSSIBLE ELECTRICAL SHOCK,MAKE CERTAIN ELECTRICITY IS SHUT OFF AT MAIN PANEL BEFORE WIRING.
All wiring must be in accordance with national and local electrical codes. If you are not familiar with wiring, you should use a qualified electrician.
This product must be installed in acordance withthe applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Ce produit doit être installé selon le code d'installation pertinent, par une personne qui connaît bien les produit et son fonctionnement ainsi que les risques inhérents.
1
Shade screws
2
Shade
3
Lamp structure
0513. Net Weight 1 Kg
Opción
Caution
Before assembling and installing this product, carefully read the following:
-Switch of the mains before installing the lamp.
-Never use a bulb with a wattage exceeeding the recommended one. Always use a bulb with the recommended wattage or lower.
-To install on the wall, always choose the most adequate fixing tools for the ceiling material.
-This lamp is for indoor use only, excluding bathrooms or any type of humid surface.
-We recommend reading the manual before installaing the lamp. Keep this instructions for future reference since thei contain Information on bulb replacing and maintenance.
Swing
Design by Lievore, Altherr, Molina
ASSEMBLY INSTRUCTIONS
SUPPLIED MATERIAL
0513
2 un.
1 un.
1 un.
TECHNICAL SPECIFICATIONS
1 x A19 Med. Base 120V 60W Max.
1 x LED 120V 1W 350mA
1 x E26 Med. Compact Fluorescent 120V 11W
1 x LED 120V 1W 350mA
1. 2.
Class I. Product with an additional protection
cable (grounds).
Product protected against solid object as big as
or bigger than 12 mm. No protection against
water.
Product that CAN be in contact with normally-
flammable materials (wood or others).
3.