en Troubleshooting
Fault
All other error codes.
"E:30/-20"
The appliance is not
working.
The programme does
not start.
44
Cause and troubleshooting
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 53
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 53
Detergent dosage is too high.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed inicio pausa + carga.
Press inicio pausa + carga.
▶
Door is not closed.
Close the door.
1.
Press inicio pausa + carga to start the programme.
2.
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 32
▶
termin. is activated.
Check whether
▶
→ "Buttons", Page 23
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press inicio pausa + carga to start the programme.
4.
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
termin. is activated.