Advertisement
User Manual
Access Control Proximity Reader with Bluetooth and Keypad
5. General Settings
•
•
•
•
•
•
•
•
•
•
•
•
User's Settings
Tap "Settings" to view or change setting functions in User's "Settings" Page. (See
Figure 10 below)
•
•
•
9
Device Name: Edit Device Name (Up to 16
characters)
Admin Passcode: Edit Admin Passcode (4~8 digits)
Admin Card/Fob: Edit Admin Card/Fob number (10
numbers on your card or key fob)
Door Sensor: Enable Door Sensor when you
connect to a closed-circuit magnetic sensor or a
monitored door lock that has door sensor (or lock
sensor) outputs to monitor the open or closed
state of a door
Lock Action (3 options): Choose Door Re-lock Time,
Door Always Unlocked, and Door Always Locked.
Tamper Alarm: If the device is vandalised, the
tamper alarm will beep immediately and won't go
off until it's switched off by Administrator.
Tamper Sensor Level: Level 1 (High Sensitivity),
Level 2 (Mid Sensitivity), Level 3 (Low Sensitivity)
Door Re-lock Time: 6 seconds by default. Edit
the Door Re-lock Time interval between 1 to 1800
seconds.
Auto Proximity Range: Adjust Auto Proximity Range here. The range is
between 0 to maximum 20 and it may have different results under different
circumstances.
Device Time: Make sure the Device Time is precisely synced with your current
time zone to have correct and precise access data and information.
About us: View Device Models, App version, Website and E-Mail information.
Firmware version: See Firmware version of your Bluetooth Access Control
Keypads/Readers.
Device Name: User can only view the Device Name. (See Figure 11 below)
Auto Proximity Range: User can adjust Auto proximity range between 0 to maximum
20 to access. May have different results under different circumstances. (See Figure 12
below)
About Us: View Device models, App version, Website information.
Figure 10
Figure 11
Figure 12
Advertisement
