Advertisement
Ready, Connect & Go!
It's easy to install, it's easy to use! Everyone can
do it.
Step1 Connect to Computer
Connect the Hawking's ADSL Router with Modem
into your computer's NIC or Switch using the RJ-
45 cable. (included)
Step2 Connect to your phone line
Connect your 10Base-T ADSL modem to your
phone line jack using a standard phone cable (RJ-
11 cable included).
Step3 Setup
Connect the Hawking's ADSL Bridge to a console
through the serial port using RS-232 cable
included to setup the modem. Then setup network
according to your operating system.
That's it. It's that easy.
Application Diagram
Connect to phone jack
With RJ-11 cable
Switch/Hub
To PC serial port
for modem setup
RS-232 cable
(included)
Features
Up to 8 Mbps
downstream / Up to
640 Kbps upstream
data rate
ATM (Asynchronous
Transfer Mode)
Framing
LED
Easy to setup
Ordering Information:
AR710 10BT 8Mbps ADSL Router w/ Modem
AM100U USB 8M bps ADSL Modem
PN9239 4-Port DSL/Cable Firewall Router w/
10/100 WAN Port
Hawking Technologies, INC.
6A Faraday, Irvine, California, USA
Sales: (888) 662-8828, (949) 580-0888
To PC's NIC
Fax: (949) 580-0880
Email: Sales@hawkingtech.com
Tech Support: (949) 580-0878
Email: Techsupport@hawkingtech.com
Web Site: www.hawkingtech.com
Copyright
Hawking Technologies, Inc. 2002. All rights
reserved. All trademarks herein are the property of their
respective owners. Product specification subjects to change
without notice
Benefits
125Times faster than
standard 56K modems
Packets are divided into small
fixed sizes for rapid
transmission over high-speed
networks
1 - Power = on or off
1 – ADSL = Status
1 – PC = Ethernet Link status
1 – RX = Receiving data
1 – TX = Transmitting data
Friendly GUI configuration
and management software
Specification:
Host Interface: 10Base-T Ethernet through RJ-45
ADSL: RJ-11 jack
Console: RS-232
Data Connection
- Downstream – Up to 8 Mbps
- Upstream – Up to 640 Kbps
- Rate – Adaptive in 32Kbps steps
Compliance
Standard Compliance ANSI T1.413 issue2
ITU-T G.992.1(Full rate DMT)
ITU-T G.992.2(Lite DMT)
ITU-T G.994.1(Multimode)
RFC 1483 BPDU(Bridge Ethernet over ATM PVC,
LLC/SNAP)
RFC 1483 RPDU(Routed IP over ATM PVC,
LLC/SNAP)
RFC 1577(Classic IP over ATM, MTU=1500)
RFC 2364(PPP over ATM)
ATM supports AAL5, AAL3/4 and AAL0
ATM Traffic shaping supports CBR and UBR
ATM Forum UNI 3.0, 3.1 and 4.0 signaling
ATM Forum ILMI 4.0
ATM Forum LANE 1.0 client, MTU=1516, over
SVC only
Transparent Bridging features conformance to
IEEE 802.1d and supports spanning tree
protocol and bridge filters
TCP/IP with RIP version 1(RFC 1058) and
version 2(RFC 1723) compatible
ARP(RFC 1293, supports only one single subnet)
BOOTP(RFC 2131, RFC 2132)
SNMP version 1(RFC 1155, RFC 1157, RFC 1213)
TELNET server(RFC 854, 855, 857, 858)
NAT server
TFTP revision 2(RFC 1350)
PPP (Point-to-Point Protocol) support
OAM F4 and F5 segment end-to-end loopback are
supported(F4 on all VPIs, F5 on VIP 0 only)
DHCP(RFC 2131, RFC 2132) server and client
PAP/CHAP user Authentication with PPP
PPTP tunneling
Dimensions:
5.9" x 5.31" x 1.38" (150mm x 135mm x 35mm)
(L x W x H)
Environment:
Temperature:
Operating: 0 – 40 C
Storage: -20 - 60 C
Humidity: 5% – 95% RH Non-condensing
Casing Material: Plastic
Weight: 300g
EMI: FCC Class B & CE
Advertisement
