Troubleshooting - Hauppauge WinTV-PVR-150 Kit Quick Installation Manual

After determining the type of signal, Media Center displays a message You are
Done!
Now, you need to set up the Electronic Program Guide. You will see a message:
Set Up Your Program Guide. Click Next. The Program Guide Set Up Wizard
will move you through the completion of the Program Guide set up.
When you are finished with the Program Guide Setup, you can start watching TV
under Media Center! Just click the MyTV button on your Media Center remote
control.
Removing the WinTV-PVR driver
If you ever need to remove the WinTV-PVR driver, run HCWClear.EXE from the
WinTV-PVR MCE Driver Installation CD-ROM.
If you cannot find the Radio button in Media Center
If you install the WinTV-PVR-USB2 MCe or WinTV-PVR-500 MCE with FM radio, but
the Radio button does not appear on the Start menu, Media Center might not
have detected the added tuner yet. Go to Radio Settings to initiate a check for
an available FM radio-enabled tuner.
To go to Radio Settings:
1. Press the START button on the remote, and then select Settings.
2. Select Radio. Media Center will check for a tuner that supports FM radio.
3. One of the following may occur:
- You will be notified if Media Center is unable to detect a tuner that supports
FM radio. Try enabling the tuner again.
- Media Center detects the tuner and the FM Radio Presets page appears.
However, if the Radio button still does not appear on the Start menu, you may
need to turn on Radio in Set Program Access and Defaults (see below).
To turn on FM radio in Set Program Access and Defaults:
1. Close Media Center.
2. Click the Start button on the taskbar, point to All Programs, and then
click Set Program Access and Defaults.
3. Select Custom. Click the down arrow button to expand the option.
4. Under Choose a default media player, select the check box next to
Media Center Radio. Click the button Enable access to this pro-
gram for Media Center Radio. When the box is selected, Radio will
appear on the Media Center Start menu; Radio will not appear if unchecked.

Troubleshooting

4