Table of Contents
Advertisement
Information on the display panel
Display
- P - and Ï
- P -
Ï flashes
| lights up
E:18
E:23
w
o lights up
Other displays
Cause/Remedy
The door is unlocked. It is possible to add laundry.
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary. Press the Ü button to continue the programme.
Laundry may be caught. Open and close the door again and press the Ü
■
button.
If necessary, push the door closed or remove some laundry and then push it
■
closed again.
If necessary, switch the appliance off and on again; set the programme and
■
make your individual settings; start the programme.
Turn on the tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter. ~ Page 28
■
The drain pump is blocked. Clean the drain pump. ~ Page 27
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 27
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services. ~ Page 32
The childproof lock is activated – deactivate it. ~ Page 22
Too must foam has been detected and an additional rinse cycle has been activated.
Add less detergent to the next washing cycle with the same load.
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call customer services. ~ Page 32
Faults and what to do about them.
en
29
Advertisement
Table of Contents
