Troubleshooting Guide - Stanley SXPW2823 Instruction Manual

• Merchandise sold by
the product of another company, such as gasoline engines. The product manufacturer's
warranty, if any, will apply.
ANY INCIDENTAL, INDIRECT OR CONSEQUENTIAL LOSS, DAMAGE,
•
OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE OR
MALFUNCTION OF THE PRODUCT IS NOT COVERED BY THIS WARRANTY.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY OR
•
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR
FROM THE DATE OF ORIGINAL PURCHASE. Some states do not allow
limitations on how long an implied warranty lasts, so the above limitations may not
apply to you.
OPERATIONAL POSSIBLE CAUSE
ISSUE
Engine will not No fuel.
start (see Engine
Pressure builds up after
Owner's
two pulls on the recoil
Manuall for
starter or after initial use
further engine
Choke lever in the "No
troubleshooting)
Choke" position
Spark plug wire
not attached.
Engine switch in
OFF po si tion
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat
for a long period of time
No or low Spray wand not in
pressure high pressure
(initial use)
Low water supply
Leak at high pressure
hose fitting
Nozzle obstructed
Water filter screen clogged Remove and clean filter. See
STANLEY
® which has been manufactured by and identified as
TROUBLE SHOOTING GUIDE
22- ENG
SOLUTION
Add fresh fuel.
Squeeze gun trigger to
relieve pres sure
Move choke to the "Choke" po si tion
Attach spark plug wire.
Place engine switch in ON position
Move choke to the "No
Choke" po si tion
See How to Use Spray
Wand instructions in the
Operation Section
Water supply must be at
least 5 gpm @ 20 psi
Repair leak. Apply sealant
tape if necessary
See Nozzle Cleaning instructions
in the Maintenance section
Cleaning Water Inlet Filter
paragraph in the Maintenance
section for the correct procedure