Product Installation - Kamoer KH Carer Quick Start Manual

Product installation

1. Install the beaker
After receiving the equipment, the user should put the beaker on the equipment for use.
（1）Gently pull out the pH electrode and put the magnetic stirring rotor into the beaker.
（2）Put the pH electrode and waste liquid discharge pipe into the beaker, then plug
them into the fixed position, and the installation is completed.
The position of the waste liquid discharge pipe depends on the inner wall of the
beaker to prevent the magnetic rotor from touching the waste liquid discharge
pipe when rotating.
2. Configuration solution
If the KH detection reagent that can be used directly is purchased, this step can be
ignored. The following describes the dilution method of KH detection reagent
concentrate.
(1) The electronic scale measures 980G RO water. 980G water corresponds to 980ml
water. RO water can be obtained from the water dispenser. Note that the reagent barrel
should be peeled on the electronic scale before taking water.
(2) Pour a bottle of KH concentrate into 980G water and gently shake the reagent barrel.
(3) Pour the mixed reagent of water and concentrated solution in the second step into
the concentrated solution bottle and rinse the concentrated solution bottle
(4) Pour the rinsed liquid back into the reagent barrel
(5) Repeat steps (3) and (4) once to complete the dilution of the concentrate.
3