Table of Contents
Advertisement
Routing matrix is initialized to Preset 0 state (defaults to source 1 connected to all destinations).
•
The button control panel is initialized and buttons are illuminated to show the initial routing status.
•
1.3 Front Panel Button Interface
The MSC-HD44L is equipped with a 4x4 button panel which provides one of several options for controlling and
viewing the status of the routing matrix.
This panel interface provides independent status and control of 4 outputs. For each output there are 4 input
buttons indicated by the digits 1 through 4 centered vertically on the panel. The currently connected input is
indicated by the input button being lit, for each of the outputs. Pressing one of the input buttons of an output
will cause that input to be connected to the given output.
1.4 Web Page Interface
All Matrix Switch Corporation router and panel devices come with a built-in web page interface.
This is the recommended interface for configuration and is also a convenient way to control the matrix routing
of the device.
Devices come factory configured with default settings, unless a pre-configuration request is made during
purchase, an example being a multi device application.
1.4.1 Accessing The Web Page Interface
The default network IP address for this device is 192.168.2.60. Refer to the table below for the default IP
addresses for other types of Matrix Switch Corporation devices.
Device Type
Video/Audio Routers
Remote Button Panels
Remote LCD Screen Panels
To access the web page interface of the device:
1. Connect the Ethernet port of a computer either directly to the device using a crossover cable or to the
same Ethernet network through a network switch or other LAN infrastructure.
2. Manually configure the computer's IP address to be a unique address on the same IP subnet as the
device. For example 192.168.2.10. The Netmask should be 255.255.255.0. The Gateway doesn't
matter for this purpose, but could be set to 192.168.2.1.
3. Make sure the device is powered on.
4. Using a web browser on the computer, enter the device's IP address into the Location bar and press
ENTER. The web page interface should load. If the web page interface fails to load, double check the
computer's network settings and physical Ethernet connections. In the event that the IP address of the
device is unknown, refer to the
Page 8 of 54
MSC-HD44L Product Manual
Unknown IP Address
Copyright © 2013-2015 Matrix Switch Corporation
Default IP Address
192.168.2.60
192.168.2.64
192.168.2.80
troubleshooting section.
www.matrix-switch.tv
Advertisement
Table of Contents
