Advertisement
Table of Contents
PARTS BAG
PART
Screw Post
Slatwall Adapters
#8 - 32 Hex Nuts
Plastic Wall Toggler
Philips Head Screws
TOOLS REQUIRED: Flathead Screwdriver (Slatwall)
Drill with 3/8" Drywall Bit & Phillips Screwdriver (Drywall)
PARTS LIST
PART
Rack
Divider
Slatwall Assembly
Align hole in Slatwall Adapter (B) with
1
back side of hole in Rack (F). Prongs extend
back toward Slatwall and up. Attach using
Screw Post (A) from front and Nut (C)
on back.
Insert Divider (G) into
2
Rack (F).
Revised 06/06/14
ASSEMBLY INSTRUCTIONS
UPC #0947 4-Tier 24" Break Resistant PETG Card Rack
Quantity
2
2
2
2
2
Quantity
1
3
NOTE: Assemble for EITHER Slatwall or Drywall, not both.
C
Reference
A
B
C
D
A
E
Reference
F
G
G
B
A
B
C
F
C
B
G
F
Page 1 of 2
D
E
A
Advertisement
Table of Contents
Related Manuals for UPC 0947
Summary of Contents for UPC 0947
- Page 1 ASSEMBLY INSTRUCTIONS PARTS BAG UPC #0947 4-Tier 24" Break Resistant PETG Card Rack PART Quantity Reference Screw Post Slatwall Adapters #8 - 32 Hex Nuts Plastic Wall Toggler Philips Head Screws TOOLS REQUIRED: Flathead Screwdriver (Slatwall) Drill with 3/8” Drywall Bit & Phillips Screwdriver (Drywall)
- Page 2 Drywall Assembly NOTE: Assemble for EITHER Slatwall or Drywall, not both. Place Rack (F) against Wall Toggler (D) Determine position on wall and insert Screw (E), and drill 3/8" holes using drill and tightening until secure. 3/8” drywall bit. Squeeze Wall Toggler (D) flat and insert into hole.
Need help?
Do you have a question about the 0947 and is the answer not in the manual?
Questions and answers