System Configuration - GREE ELECTRIC ETAC2-07HP230VA-CP Installation & Owner's Manual

SYSTEM CONFIGURATION

VENTILATION CONTROL
The unique ventilation system is activated by a two
position control. Fresh outside air is redirected by
the vent door to the indoor room.A polymer air filter
prevents dirt and debris from entering the room from
outdoors.The ventilation control lever is located at
left side of unit, behind the front panel.
UNIT DAMAGE HAZARD – Failure to follow this
caution may result in equipment damage or improper
operation. Failure to remove shipping tape and
screw will prevent fresh air vent door from opening
and may result in damage to vent door cable.
NOTE: The vent door is screwed shut for shipping
purposes. Remove shipping screw before using vent
control lever. See Installation Instructions.
When vent is set at CLOSE, only the air inside the room
is circulated and filtered.
When vent is set at OPEN, some outdoor air will be drawn
into room. This will reduce heating or cooling efficiency.
ADJUSTING AIR DIRECTION
Louver screws
The bi-directional discharge grille is constructed of durable polycarbonate and is reversible.Air flows
upward at a 40 degree angle to the floor but can easily be adjusted to an 80 degree angle to the floor.
To adjust air direction:
1. Remove front panel.
Louver screws
2. Remove louver screws that
hold louver insert in place
(from back side of front panel).
3. Turn louver insert and rotate 180°.
4. Replace louver insert.
Air discharge upward
5. Replace screws and front panel.
WARNING
CAUTION
C UTION
WARNING
SHIPPING SHIPPING
TAPE TAPE
Louver screws
Louver screws
Air discharge upward
Fig. 13 – Shipping Screw Removal
Fig. 14 – Ventilation Control
Louver screws
Louver screws
Fig. 15 – Backside of Front Panel
Louver screws
Louver screws
Air discharge upward
Air discharge upward
Air discharge outward (Default)
Fig. 16 – Adjusting Louvers
Adjusting Louvers
REMOVE SHIPPING REMOVE SHIPPING
SCREW IF PRESENT SCREW IF PRESENT
Vent Control (Pull
lever through label
to operate.)
Louver screws
Louver screws
Air discharge outward (Default)
Air discharge outward (Default)
Air discharge upward
Air discharge outward (Default)
Adjusting Louvers
Adjusting Louvers
A
14