Wheel Truing Tool - Cannondale 120027.PDF Owner's Manual Supplement

wheel trueing tool
This special tool is needed to mount the 12 mm Thru axle wheels in trueing stands. Using it
ensures proper wheel dish,
CAP
O-RING
NON-DRIVE
rear wheel removal and installation
Here are some things you must remember when removing and reinstalling the rear wheel:
1. Keep your hands and fingers from between the wheel and the swingarm, and out of the
shock linkage.
2. Always clean the axle and dropout clamps surfaces before reinstallation.
3. Make sure that the dropout clamps are attached to the swingarm correctly.
Follow tightening order.
4. Use an accurately calibrated torque wrench and follow the tightening order shown. Pay
attention to GAP and NO GAP. See previous page.
Order Cannondale Kit KF079/
29
SHAFT
120027.PDF
DRIVE