English Add the bar and chain oil........6 Description......... 2 Assemble the guide bar and the chain....6 Purpose.............. 2 Install the battery pack........7 Overview............2 Remove the battery pack........7 Packing list............2 10 Operation........... 7 General power tool safety 10.1 Examine the chain oil........
English DESCRIPTION GENERAL POWER TOOL SAFETY WARNINGS PURPOSE WARNING This chainsaw is designed for cutting branches, trunks, logs Read all safety warnings and all instructions. Failure to and beams of a diameter determined by the cutting length of follow the warnings and instructions may result in electric the guide bar.
English • If devices are provided for the connection of dust contacts eyes, immediately seek medical help. Liquid extraction and collection facilities, ensure these are ejected from the battery may cause irritation or burns. connected and properly used. Use of dust collection can SERVICE reduce dust related hazards.
English • Cut wood only. Do not use chainsaw for purposes not Symbol Explanation intended. For example: do not use chainsaw for Precautions that involve your safety. cutting plastic, masonry or non-wood building materials. Use of the chainsaw for operations other than intended could result in a hazardous situation.
English ENVIRONMENTALLY SAFE PROPOSITION 65 BATTERY DISPOSAL WARNING This product contains a chemical known to the state of California to cause cancer, birth defects or other reproductive harm. Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm.
English ADD THE BAR AND CHAIN OIL Examine the amount of oil in the machine. If the oil level is low, add the bar and chain oil as follows. IMPORTANT Use bar and chain oil that is only for chains and chain oilers.
English INSTALL THE BATTERY PACK 10.2 HOLD THE MACHINE 1. Hold the chainsaw with your right hand on the rear WARNING handle and left hand on the front handle. • If the battery pack or charger is damaged, replace the 2.
English • Ensure there is no dirt, stones, loose bark, nails, and staples on the tree. 2’’(50mm) 2’’(50mm) 1. Start the machine. 2. Push the guard forward to to engage the chain brake. 1. Make a lower level notching cut (27). Make sure that 3.
English 10.7 LIMB A TREE Limbing is the removal of the branches from a fallen tree. 1. Keep the larger lower branches to hold the log off the ground (31). When the log is held on two ends (37), 2. Remove the small limbs (30) in one cut. 1.
English WARNING NOTE Remove the battery pack from the machine before During normal saw operation, the temperature of the chain maintenance. increases. The drive links of a correctly tensioned warm chain will hang approximately 1/16 in. (1,58 mm) out of the bar groove.
English 1. Lubricate the bearings on the nose sprocket (if present) with the syringe (not included). 2. Clean the bar groove with the scraping hook (not included). 3. Clean the lubrication holes. 4. Remove burr from the edges and level the cutters with a flat file.
English TROUBLESHOOTING Problem Possible cause Solution The motor runs Sharpen or replace Problem Possible cause Solution The chain is blunt. and the chain ro- the saw chain. tates, but the chain The guide bar and The chain is too Adjust the chain Turn the chain does not cut.
English TECHNICAL DATA HELPLINE: Warranty service is available by calling our toll-free helpline, Voltage 80 V DC at 1-855-345-3934. No load speed 10.5 m/s TRANSPORTATION CHARGES: Guide bar length 18'' (458 mm) Transportation charges for the movement of any power Chain pitch 3/8”...
Need help?
Do you have a question about the 2019002CO and is the answer not in the manual?
Questions and answers