Adding Or Replacing A Dc Pem - Cisco DC Power Entry 10005 ESR Installation Manual

Adding or Replacing a DC PEM

Adding or Replacing a DC PEM
Note
Installing a Second DC PEM
Warning
Caution
Step 1
Step 2
Step 3
Cisco 10005 ESR DC Power Entry Module Installation
8
This section describes how to add or replace a DC PEM in a Cisco 10005 chassis.
It contains these procedures:
Installing a Second DC PEM
•
Replacing a DC PEM
•
Wiring a DC PEM
•
Troubleshooting the Installation
•
Before you perform any of the procedures in this document, be sure that you
have connected the chassis to earth ground as described in the
Cisco 10005 ESR Hardware Installation Guide.
Never install an AC power module and a DC power module in the same
chassis.
Follow these step to install a second DC PEM for redundancy.
Do not power off the DC PEM that is providing power to the router. If you do
so, all data traffic halts.
Put on an antistatic wrist or ankle strap. Connect the strap to the ESD jack on the
front of the chassis or to a bare metal surface of the chassis.
Ensure that the power switch on the new DC PEM is set to 0 (Off).
Insert the new DC PEM
secure connection to the midplane. Tighten the captive screws.
(Figure 2) all the way into the power bay to ensure a
78-12653-01