Operation; Start Charging; Stop Charging; Led Indicator - Delta AC MAX Installation And Operation Manual

4

Operation

Turn on the upstream breaker. The indicator flashes in yellow during a system self-test. After the self-test
completed, the indicator illuminates in blue and the EVSE is ready to charge.
4.1

Start charging

1. Connect the vehicle connector to vehicle inlet.
2. Place the RFID card over the sensor area to initiate the charging process.
Note:
a. Successful card detection is indicated by two short beeps. A long beeping sound indicates authentication
failure. Please check your card and try it again.
b. The EVSE returns to standby mode if the vehicle connector is not connected to the EV within 60 seconds
after card authentication.
3. The indicator flashes blue to indicate the charging is initiated.
4.2

Stop charging

1. Stop charging session at the vehicle or swipe the RFID card again to stop the charging process.
2. Disconnect the vehicle connector from the vehicle inlet.
Note: the plug would be locked by the EV and please unlock the plug if needed.
3. Recover the vehicle connector to vehicle connector inlet.
5

LED Indicator

Status
Black
Yellow, fast flashing
Blue
Yellow
Blue, slow flashing
Green
Yellow, 1 Flash
Yellow, slow flashing
Red, slow flashing
Red
Description
Power off.
Initial configuration and self-test.
Standby mode (not connecting to EV).
Ready to charge (connecting to EV).
Charging in progress.
Charging process completed or network connection success.
Network connection fail
Limited output power by OCPP command, firmware upgrade or log
download.
Refer to fault event.
Failed self-test, general malfunction
30
v1.0.1