S E AT B E LT S W A R N I N G L A M P
2
OPERATION
The driver's and the front and rear
passengers' seats have sensors
that
detect
non-fastening/unfas-
tening of the seat belts.
The fastened/non-fastened status
of the seat belts for each type of
seat is indicated by the illumination
2 and 3.
FUNCTIONING OF THE SYSTEM OF DETECTION
3
Driver's and front passenger's seats
When you switch on the ignition:
•
If
If the driver's seat belt is not fastened, the warning lamp
the instrument panel.
•
If the passenger's seat belt is not fastened, the warning lamp
If
up.
utes. After that, warning lamps 1 and/or 3 remain on.
Rear passengers' seats
When you switch on the ignition, warning lamp 2 lights up to make the driver
and any passengers aware.
Once the doors are closed and the engine started, a message tells you the
fastening status of the rear belts for 30 seconds.
After this time, if one or more of the rear belts are not fastened:
•
The warning lamp 2 comes on if your speed is less than approx. 20 km/h
•
The warning lamp 2
1,
signal, for about two minutes if your speed is greater than around 20 km / h
Note:
•
The detection of non-fastening of rear seat belts is deactivated when you
switch off the ignition or if one of the vehicle's doors is opened.
•
A child seat installed on the front passenger's seat may not be
1
detected.
The driver, after he has closed the doors and started the engine, must
make sure that the passengers:
•
Have all fastened their seat belts
•
Are using the seat belts correctly.
II
1 illuminates in
3 lights
31