Table of Contents
Advertisement
Entry via a zone with the Entry/Exit option will trigger an instant
alarm.
Similar to Instant Stay Mode, Night Mode requires the system
to be disarmed (from inside or remotely) before entering the
protected partition. When switching to Night Mode, Stay zones
remain bypassed (i.e. the bedroom) while Night zones become
active (i.e. the hallway). Night Mode is a 3
providing higher security and is typically used when staying
upstairs and where no more persons are expected downstairs.
System Events Preventing Arming
The following system events may prevent you to arm your
security system. Depending the Security Grade, either you or
your installation company needs to acknowledge these faults
before arming will be allowed. See next chapter or contact
your installation company for assistance.
•
Wireless sensor supervision faults
•
Wireless sensor Low Battery
•
Tamper
•
Trouble
•
Ethernet or WiFi fault
•
Phone Line Fault
•
Wireless Jamming
•
Over-current fault
•
AC Mains fault
•
Backup Battery fault
•
Expander fault
Acknowledging System Events
When the Status Key is red, there may be latched system
events present. A master user (Level 2) or Installer (Level 3)
may be required to acknowledge and clear these events.
Standard users cannot acknowledge and clear system events.
To acknowledge Latched System Events:
Enter a valid master PIN code to unlock the screen.
Touch the Off or Off + button followed by ENTER
acknowledge the event:
The Status button will change to green if no other conditions
are present.
Exit Error / Fail to Close
If during exit delay a zone is tripped which causes an alarm,
then the partition(s) affected will not be armed. An Exit Error
and Fail To Close event are logged in the xGen event history.
Check the zone is secure and try to arm the partition(s) again.
Disarm One or More Partitions
Enter a valid PIN code to unlock the screen.
Typically the buzzer will sound (continuous tone) announcing
the entry delay.
P/N 230444 • REV J • ISS 16MAR21
Touch the Off or Off + button to disarm your system:
If your system has multi-partition control enabled, the Off +
rd
arming mode
button will be displayed.
Also a number will appear above the icon indicating the
number of partitions that are in the state the icon represents.
A valid PIN code will need to be entered to determine what
permissions they have, this includes which partitions and at
what time/day that user has access.
Disarm After an Alarm
When an alarm condition occurs the screen may make a
constant beeping sound.
Enter a valid PIN code to unlock the screen.
. to
The colour coded section provides further information about
the alarm condition, including the zone description (if
applicable).
For more details, touch the Status button. The partition and
zone(s) that caused the alarm will be displayed. Touch the
partition or zone number on the screen for a description.
Touch Details for more details on the type of alarm:
3 / 8
Advertisement
Table of Contents
