CADDX NXG-1820-EUR User Manual page 2

System Status
The xGen will display colour coded system status messages
on the top of the main screen.
• Red – critical messages including alarm
• Yellow – zones bypassed
• Blue – system (fault) conditions present
• Green – system is normal
Arm Your System in Away Mode
Enter a valid PIN code to unlock the screen.
Touch the Away or Away + button to arm your system in Away
mode:
The icon will change to red when the alarm system is set in
away mode.
A buzzer will sound (beeping) announcing the exit delay.
Leave the premises during this time.
If your system has multi-partition control enabled, the Away +
button will be displayed.
Also a number will appear above the icon indicating the
number of partitions are in the state that the icon represents.
A valid PIN code will need to be entered to determine what
permissions they have, this includes which partitions and at
what time/day that user has access.
Arm Your System in Stay Mode
Enter a valid PIN code with Stay permissions to unlock the
screen.
Touch the Stay or Stay + button to arm your system in Stay
mode:
The icon will change to yellow when alarm system is set in
Stay mode.
2 / 8
Touching the Stay Mode button again will cycle the system to
Instant Stay Mode if this feature is enabled by your installation
company.
In Stay Mode – Entry/Exit zones will be active, and zones with
the Stay or Night Mode zone option will be bypassed. Entry via
a zone with the Entry/Exit option will start the partition entry
time.
Stay Mode will allow you to move around inside your home or
office building without causing the system to sound an alarm,
whilst entrance doors and windows remain active. A person
entering the protected partition will have to disarm the system
during the entry time.
Look at the colour coded status bar to see which zones that
are bypassed or touch the Status button.
If your system has multi-partition control enabled, the Stay +
button will be displayed.
A number will appear above the icon indicating the number of
partitions that are in stay mode.
Arm Your System in Instant Stay Mode
Enter a valid PIN code with Stay permissions to unlock the
screen.
To arm in Instant Stay mode touch the Stay button two times
until the icon is red and displays "Instant":
This indicates the alarm system is set in Instant Stay Mode.
Touching the Instant Mode button will cycle the system to
normal Stay Mode or Night Mode if this feature is enabled by
your installation company.
In Instant Stay Mode – Entry/Exit zones will be active with the
entry delay time removed and zones with the Stay or Night
Mode option will be bypassed. Entry via a zone with the
Entry/Exit option will trigger an instant alarm.
Instant Stay Mode provides a higher level of security and
requires the system to be disarmed (from inside or remotely)
before entering the protected partition. Attempts to enter the
partition will trigger an instant alarm with no entry delay.
Arm Your System in Night Mode
Enter a valid PIN code with Stay permissions to unlock the
screen.
To arm in Night Mode touch the Stay or Stay + button a total of
three times until the icon is red and displays "Night Mode":
Touching the Night Mode button again will cycle the system
back to Stay Mode.
In Night Mode – Entry/Exit zones will be active with the entry
delay time removed, zones with the Stay option will be
bypassed, and zones with the Night Mode option will be active.
P/N 230444 • REV J • ISS 16MAR21