Table of Contents
Advertisement
10. INSTALLING THE
LIGHT KIT
NOTE: Before starting installation,
disconnect the power by turning off
the circuit breaker or removing the
fuse at fuse box. Turning power off
using the fan switch is not sufficient to
prevent electric shock.
1. Raise and hold the light kit close to
the mounting plate and proceed to
do the wire connections. Connect the
white wire connectors from the light
k i t a n d f a n , f o l l o w t h e s a m e
p r o c e d u r e w i t h t h e b l a c k w i r e
connectors. (Fig. 16)
2. Carefully push all wires back into the
mounting plate, then install the light
kit onto the mounting plate with 3
screws provided. Be sure to tighten
all screws. (Fig. 16)
11. INSTALLING THE
LIGHT BULBS & GLASS
SHADE
1. Install 3 x 40w candelabra bulbs (not
included). (Fig. 17)
2. Place glass shade over the light kit
stem, secure with th rubber washer,
m e t a l
n u t ,
decorativenut. Do not overtighten
(Fig. 17)
3. Restore power and your light kit is
ready for operation.
g l a s s
c a p
a n d
Connection plugs
Light kit
Bulbs
Glass shade
Rubber washer
Metal nut
Glass cap
Decorative nut
8
Mounting
plate
Screws
Figure 16
Light kit
Figure 17
Advertisement
Table of Contents
