Husky VT631404 Use And Care Manual page 15

Installation - Electrical (continued)
4
Securing the strain relief
□ Tighten the strain relief nut (1). Place a fl athead
screwdriver into the raised notch, and tap the screwdriver
with a hammer until tight.
□ Tighten the strain relief screws (2) to hold the power cord
securely.
Reinstalling the pressure switch
5
cover
□ Replace the pressure switch cover. The knob must be in the
same position as when removed to sit correctly in place.
□ Tighten the pressure switch screw (1) with a Phillips
screwdriver. Check that the switch is in the OFF position.
Follow the break-in procedure from the owner's manual.
15
Please contact 1-888-43-HUSKY for further assistance.
2
1
HUSKYTOOLS.COM