Solo Music Gear BCK-1 Assembly Manual

Solo bc style diy electric guitar kit

Table of Contents

Download this manual

Solo BC Style DIY

Electric Guitar Kit

Assembly Manual

BCK-1

V 1.02

Table of Contents

Need help?

Do you have a question about the BCK-1 and is the answer not in the manual?

Page 2 Post your photos to The Solo Café http://TheSoloCafe.com Remember, you can always find us online at http://SoloMusicGear.com to upgrade your parts, try a new kit, or ask us a question. Copyright © 2011 Solo Music Gear. All rights reserved v1.02...
Page 3 STEP 1 – The body and neck have been coated with a poly resin sealant. They need to be sanded before finishing. DO NOT SAND THE FINGERBOARD. For sanding both neck and body, use a flat sanding block for all flat surfaces and by hand for edges and Copyright © 2011 Solo Music Gear. All rights reserved v1.02...
Page 4 For tapping, you can use either a plastic headed hammer, or a regular hammer, by placing a small piece of wood on the top of a bushing to prevent any potential damage. Tap the other tailpiece Copyright © 2011 Solo Music Gear. All rights reserved v1.02...
Page 6 A higher string action makes the guitar harder to play, yet some musicians may prefer it. Tailpiece height can regulate string pressure over the bridge, changing both tone and sustain. Copyright © 2011 Solo Music Gear. All rights reserved v1.02...
Page 7 – you may find it more satisfactory sounding by setting it somewhat angled, depending on what you are looking for in the output sound. There are a few mm of real usable range where you can find the pickup tone that you’ll like the best. Copyright © 2011 Solo Music Gear. All rights reserved v1.02...