Advertisement
Installation (continued)
3
Placing photocell on fixture
NOTE: The fixture comes with the twist-lock
photocell (B) provided separately in the box.
☐ Photocell (B) must be inserted into the
receptacle for fixture to turn ON.
☐ OPTIONAL: To deactivate Automatic
Dusk to Dawn Functionality, place the
included photocell cover sticker (DD) on
photocell window.
☐ Place the photocell (B) onto the
receptacle on top of the fixture.
☐ Twist the photocell (B) in the direction of
the arrow indicated on the photocell until
it locks into place.
4
Preparing for mounting the fixture
Wall Mount
NOTE: The fixture comes with the wire guard
protection plate (C) already installed on the
fixture arm(D).
☐ Remove the wire guard protection plate
(C) from the arm (D) of the fixture by
loosening the screws.
☐ Mark and pre-drill the three holes on the
desired location of the mounting surface.
Extension Arm Mount
☐ Remove the wire guard protection plate
(C) from the arm (D) of the fixture by
loosening the screws.
Visit www.probrite.com/install for installation video tutorials and product support
B
NOTE: The light fixture will not work without
the photocell inserted into the photocell recep-
tacle as it completes the circuit.
NOTE: Make sure the photocell is locked on the
receptor. Do not over rotate after it is locked.
CAUTION: Do not try to rotate the photocell
receptacle on top of the fixture as it may twist
D
6
Installation (continued)
5
Mounting the fixture
☐ Feed supply wires through the arm (D)
Wall Mount
D
☐ Attach the fixture to the wall using the
three hex head bolts (AA) and the flat
washer (CC).
NOTE: Use other suitable bolts or fasteners as
applicable to your mounting surface.
TIP: After marking and predrilling the three
mounting holes, partially screw the bottom
hex bolts with washer and place the fixture's
two bottom mounting groves onto the bottom
bolts, then insert the top bolt, and tighten all
bolts to firmly secure fixture to surface.
Extension Arm Mount
☐ Secure the extension arm to the light
fixture arm (D) using the included arm
mounting bracket (EE) and the screws
removed earlier, until the bracket pushes
firmly against the arm mount.
IMPORTANT INFORMATION: Extension Arm is available and sold separately. If you need to purchase the
extension arm please contact your retail store.
Installation instructions for the extension arm are available in the instructions sheet provided in the exten-
sion arm package.
6
Making the electrical
connections
C
Wall Mount
☐ Place rubber grommet (FF) into the hole
of the wire cover plate before threading
wires through.
☐ Thread the wires through the hole in the
wire cover plate (C) before making wiring
connections (fig 1).
Extension Arm Mount
7
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
CC
X3
D
AA
X3
Wall Mount
D
EE
D
FF
(fig 1).
C
PROBRITE.COM
Advertisement
