Summary of Contents for Campania International Longvue FT-225
Page 1
FT-225 Longvue Fountain Assembly Instructions Fountain Information: • Two people are recommended for the installation of this fountain! • This fountain holds approximately 10 gallons of water. • This fountain uses a medium fountain cover: FTNCOV-MED • Compatible with a LED kit •...
Page 2
FT-225 Longvue Fountain Assembly Instructions Two people are recommended for the installation of this fountain! Fountain Set-Up: Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin.
Page 3
FT-225 Longvue Fountain Assembly Instructions Step 8 - Center the small bowl (FT-225B) over the pump house (FT-225C). Step 9 - Use a hose clamp to secure the loose end of the non-kink tubing to the pipe protruding from the bottom of the small bowl (FT-225B). FT-225C (39 lbs) 21.5"W x 6.75"H Step 10 - Center the finial (FT-225A) over the small bowl (FT-225B).
Page 4
Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - Ensure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.