Harman Kardon AVR 7200 Owner's Manual page 47

few minutes for the reset process to take place,
and the length of time will vary depending on how
much customization and programming has taken
place. Please be patient; as long as the message
appears in the display the remote is functioning
properly.
R E S E T T I N G . . .
Figure 75
4. When the remote has been totally reset and
returned to the factory default condition, a
REMOTE RESET COMPLETE message will
appear (Figure 76) briefly, and then the remote will
return to normal operation.
R E M O T E R E S E T
C O M P L E T E
Figure 76
Additional Notes on Configuring and Operating
the Remote:
• When the remote is being programmed, it will auto-
matically time-out if no button is pressed within a
thirty-second period. The message shown in Figure
78 will appear briefly, and the remote will then exit
the feature being programmed and any data entered
will be lost.
T I M E O U T O R
C L R K E Y P R E S S E D
Figure 77
• The programming or configuration process may
also be stopped at any time by pressing the Clear
Button 9. The message shown in Figure 77
will appear, the data entered in the current process
will be lost and the remote will return to normal
operation. Any process that was underway when
the button will be pressed must be restarted.
• Extensive use of the programming, learning and con-
figuration functions of the remote may consume sig-
nificantly more battery power than normal remote
operation. While the batteries should last for four to
six months in normal operation, you may find that
they need to be changed sooner after the remote is
programmed for the first time.
• When the batteries approach a level below which the
remote will not function, the remote's LCD screen will
display a LOW BATTERY warning as shown in
Figure 78. We strongly recommend replacing the
batteries as soon as this message appears to avoid
the loss of programming and configuration settings.
These settings are not lost when the batteries are
changed quickly.
A V R
L O W B A T T E R Y
Figure 78
CONFIGURING THE REMOTE
• The remote has a built-in backlight that may be
activated by pressing the Light Button P. This
button is made from a special "glow" material so
that it is easier to find in dark rooms. This glow
feature does not consume any electricity, but the
glow will fade when the remote is kept in a dark
location for an extended period of time. The "glow"
feature may be restored by placing the remote in
normal room light for a few hours.
• The remote's backlight will remain lit for approxi-
mately five seconds after the Light Button P is
pressed, and it will stay lit for another five seconds if
any key is pressed while the backlight is on. You may
keep the backlight lit by holding the Light Button, but
extensive use of the backlight will reduce battery life.
• The LCD display will remain on for ten seconds
after a key is pressed and then turn off to conserve
battery life.
• When any button is held for more than thirty
seconds the LCD will turn off and the remote will
stop transmitting the codes to conserve battery life.
CONFIGURING THE REMOTE 47