Peration; Care - Broan EW4330SS Installation Use And Care Manual

13. OPERATION
Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the blower run for a few minutes to clear the
air after you turn off the range. This will help keep the whole kitchen cleaner and brighter.
1. b oN/s
lower peeD INcrease key
Press the Blower ON/Speed increase key to activate the blower at low speed. Press twice for medium speed and once more for high
speed. The LED indicator below the key will light according to the speed level chosen (one LED = low speed, 2 LEDs = medium speed,
3 LEDs = high speed). Press once more to turn OFF the blower; the LED indicators will then shut off.
2. m oN/oFF / D
aster elay oFF key
When blower and light are ON, press the Master ON/OFF key to turn OFF both blower and light. When blower and light are OFF, press
this key to turn ON the blower to the previous speed setting and turn ON the light at the previous light intensity.
D : When a blower speed is selected, press and hold this key for 3 seconds to activate the delay function. The corresponding
elay oFF
blower speed LED indicator(s) will flash to indicate this function is activated. The blower will continue to operate for 10 minutes and will
stop automatically.
To cancel the delay function, press this key once again, the blower and the light (if ON) will turn OFF.
3. l + oFF
Ight INteNsItIes
Press this key once to turn ON the light on low intensity, one LED indicator will light. Press once more to turn the light on high intensity
(both LED indicators will light). Press another time to turn OFF the light (both LED indicators will then shut off).

14. CARE

Grease Filter(s)
Grease filter(s) should be cleaned frequently. Use a warm dishwashing detergent solution to clean the filter(s). Grease filter(s) are
dishwasher safe.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filters may occur if using phosphate
detergents, or as a result of local water conditions - but this will not affect filter performance. This discoloration is not covered by the
warranty. To minimize or prevent discoloration, hand wash filters using a mild detergent.
Non-ducted Filter(s)
Change the non-duct recirculation filter(s) every 6 months. Purchase S99010473 for 24-in. and 30-in. widths range hoods or S99010474
for 36-in. width range hoods.
Hood Cleaning
Stainless Steel Cleaning:
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be
used close to a range.
1
HC0088
1) Blower Speed key + OFF
(D
ouble FuNctIoN key
(
Double FuNctIoN key
:
key
2
2) Master ON/OFF key + Delay off
):
)
Don't:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the hood to make
sure no dust sticks to stainless steel surface.
10
3
3) Light Intensities + OFF key