Related Manuals for Broan Elite EW54000 Series
Summary of Contents for Broan Elite EW54000 Series
- Page 1 INSTALLATION INSTRUCTIONS HB0198 EW54 SERIES INTENDED FOR DOMESTIC COOKING ONLY READ AND SAVE THESE INSTRUCTIONS INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER. HOMEOWNER: USE AND CARE INFORMATION ON PAGE 13.
-
Page 2: To Reduce The Risk Of Fire, Electric Shock Or Injury To Persons, Observe The Following
WARNING WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR TO REDUCE THE RISK OF INJURY TO PERSONS IN THE INJURY TO PERSONS, OBSERVE THE FOLLOWING: EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address 1. -
Page 3: Prepare The Installation
1. PREPARE THE INSTALLATION WARNING When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves. NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer. Make sure that the following items are included: - Hood - Accessories •... -
Page 4: Remove Grease Filters
2. SELECT INSTALLATION TYPE (CONT'D) Refer to illustrations below to locate duct opening according to discharge type chosen (grey parts to be installed later). ERTICAL DISCHARGE ORIZONTAL DISCHARGE ” ” 9¾” 3” 3¼” ” 3¼” 9¾” ” ” 30” WIDTH HOOD ”... - Page 5 4. CHOOSE THE OPENING OR VERTICAL DISCHARGE OR NON DUCTED INSTALLATION From outside the unit, remove the knockout in order to clear vertical discharge opening (see illustration beside). HR0122 OR HORIZONTAL DISCHARGE From outside the unit, remove the knockout from back of hood (see illustration beside). HR0123 5.
-
Page 6: Wiring Installation
6. INSTALL ADAPTER/DAMPER (6” ROUND OR 3¼” 10”) Mount the 6” round adapter/damper (included in bag) using 4 no. 8 x 3/8” screws (included) or the 3¼” x 10” adapter/damper to the hood using 2 no. 8 x 3/8” screws (included). Seal the adapter/damper to the hood using metal foil duct tape. 6”... -
Page 7: Install Hood Mounting Bracket
8. INSTALL HOOD MOUNTING BRACKET WARNING ALL STUDS When cutting or drilling into wall, do not damage electrical wiring and other hidden utilities. RAMING BEHIND DRYWALL Construct wood wall framing that is even with the surface of wall studs. Wood wall framing must be at least 1/2” thick and 3” high. Fasten wood wall framing to wall studs for a solid installation. - Page 8 11. REINSTALL BLOWER (HORIZONTAL DISCHARGE ONLY) 1. Position the blower on the inner back of the hood, as shown on the right. 2. Using a 5/16” socket, or a Robertson or a Phillips no. 2 screwdriver and the 4 screws previously removed, secure the blower to the hood.
- Page 9 13. DUCT CONNECTION (VERTICAL DISCHARGE AND NON-DUCTED INSTALLATION ONLY) ERTICAL DISCHARGE Plug hood power cord into the outlet. Slide a 6” round or a 3¼” x 10” metal duct over the adapter/damper on the hood. Use metal foil duct tape to seal the joint. HJ0142 HJ0141 DUCTED INSTALLATION...
-
Page 10: Prepare The Decorative Flue
14. PREPARE THE DECORATIVE FLUE UCTED INSTALLATION Remove protective plastic film covering the lower flue only. Peel off both corners at the top of the upper flue (note that upper part has one hole on left and right sides; see image on the right). Position the lower flue rear notches down. -
Page 11: Install Decorative Flue
15. INSTALL DECORATIVE FLUE LL INSTALLATIONS Carefully slide in place decorative flue base (notches end first) in the groove (shaded part in inset at right) behind the exterior wall of the top of the hood. HO0272 PPER FLUE MOUNTING BRACKET RONT VIEW UCTED INSTALLATION PPER... - Page 12 (A) after installation. HD0939 17. LIGHTING The Broan Elite EW54 Series range hoods require two shielded Halogen Bulbs (120 V, 50 W max., MR16 or PAR16 with GU10 base), included. See service parts list for replacement bulbs. WARNING Do not touch lamps during or soon after operation.
-
Page 13: Operation
18. CARE WARNING Before servicing or cleaning the unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. Grease Filters The grease filters should be cleaned frequently. -
Page 14: Wiring Diagram
20. WIRING DIAGRAM 1 2 3 4 5 6 COLOR CODE BLACK ORANGE Override BLUE BROWN WHITE GREY YELLOW User interface mounted to J10 on back of control board. BK (High) O (Medium) R (Low) FAN MOTOR Control Board Line Neutral Ground HE0269A... -
Page 15: Service Parts
HARCOAL FILTER CLIP SET OF ARTS . 8-18 3/8” SCREWS SV05803 1/2” B LACK SCREWS . 8-18 3/4” SCREWS WASHERS 1/2” DRYWALL ANCHORS SCREWS HL0384 OT SHOWN When it comes to quality home appliances, Broan-NuTone is the brand you can depend on.
Need help?
Do you have a question about the Elite EW54000 Series and is the answer not in the manual?
Questions and answers