Set The Time - Suresafe GO Plus User Manual

22

Set The Time

Your alarm should tell the correct time based on your
location automatically. It does this using satellite signal.
You can manually adjust the time zone by sending the
following text commands:
Text Command: tz(+/-)(hours):(minutes)
Example 1: To move the time forward 2 hours+: tz+02
Example 2: To move the time forward 2 hours 15 minutes
text: tz+02:15
Example 3: To move the time back 4 hours+: tz-04
Example 4: To move the time back 4 hours 15 minutes text:
tz-04:15
Notes:
Use the + (plus) or – (minus) signs to indicate whether the
time should go forward or back. Hours must use 2 digits, for
example 7 hours must be texted 07. Minutes must be in 15
minute increments for example only 0, 15, 30 and 45 can be
used for changing the minutes.