GE PLD617RT Owner's Manual And Installation Instructions page 19

1. OVEN PREPARATION (Cont.)
■ Attach the range oven in the cabinet opening
by driving four screws into the countertop.
Install 2 screws per side using preferred hole
options based on countertop construction. If
countertop is wooden, start by drilling pilot
holes with a 1/8" drill bit. Drive the 4 provided
screws into the holes to attach.
2. GAS SUPPLY
WARNING
Fire Hazard: Do not use a
flame to check for gas leaks.
WARNING
Explosion Hazard: Do not
exceed 25 ft-lbs of torque when making gas
line connections. Overtightening may crack
the pressure regulator resulting in fire or
explosion hazard.
WARNING
Gas leaks may not be
detected by smell alone. Gas suppliers
recommend your purchase and install an
UL approved gas detector. Install and use
in accordance with the manufacturer's
instructions.
Gas Pressure Regulator
You must use the propane gas pressure
regulator supplied with this range. For proper
operations the inlet pressure to the regulator
should be as follows:
Minimum pressure: 11" of Water Column
Maximum pressure: 13.8" of Water Column
49-2001047 Rev. 3
Installation Instructions
2. GAS SUPPLY (Cont.)
Connect a propane supply line with a 3/8" Flare
Female connection to the regulator in the upper
right rear corner of the cabinet
Tighten the gas line to the regulator using 2
wrenches.
IMPORTANT: Leave adequate space around
the gas supply pipe in case of bend or damage
during installation. Make sure the gas supply
pipe cannot contact any moving parts after
installed.
When using pressures greater than ½ psi
(3.5kPa) to test the gas supply system of the
RV, disconnect the range and individual shut-off
valve from the gas supply piping. When using
pressures of ½ psi (3.5kPa) or less to pressure
test the gas supply system, simply isolate the
range from the gas supply system by closing the
individual shut-off valve.
Propane Supply
Line Connection
19