Installation Guidelines; Required Tools And Equipment - Cisco Blower Module 10000 ESR Installation Manual

Installation Guidelines

Warning
Note
Installation Guidelines

Required Tools and Equipment

Cisco 10000 ESR AC Power Entry Module Installation
4
This warning symbol means danger. You are in a situation that
could cause bodily injury. Before you work on any equipment, be
aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. To see
translations of the warnings that appear in this publication, refer
to the Regulatory Compliance and Safety Information document
that accompanied this device.
If you need translations of the safety warning, see the Cisco 10000
ESR Hardware Installation Guide.
The Cisco 10000 system is hot-swappable, which means you can remove and
replace a defective PEM while the system is operating (assuming that your system
has a second AC PEM installed for redundancy). It is not necessary to notify the
software or reset the system power. This feature lets you add, remove, or replace
a second PEM while the system maintains all routing information and ensures
session preservation.
You need the following tools and equipment to install an AC PEM:
A Number 2 Phillips screwdriver
•
3/16-inch flat-blade screwdriver
•
An electrostatic discharge (ESD) preventive wrist or ankle strap with
•
connection cord
78-10832-01