Festool MFK 700 EQ Original Instructions Manual page 8

English
8.3 Changing tools
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Before replacing the cutter remove the router
table.
4
2
3
Removing the tool
► Push spindle lock [4-1].
► Slacken union nut [4-2] using open ended
spanner (SW 19) until the tool can be re­
moved.
► Release spindle lock [4-1].
Inserting the tool
► Position the cutter [4-3] as far as possible,
at least as far as the marking
cutter shaft, into the open clamping collet.
► Push spindle lock [4-1].
► Tighten union nut [4-2] using open ended
spanner (SW 19).
► Release spindle lock [4-1].
8
4-1
1
4-2
4-3
at the
8.4 Replacing clamping collet
Only suitable tools can be used with the sup­
plied collets. Collets with 8 mm, 6 mm and 1/4"
(6.35 mm) can be used.
► Push spindle lock [5-1].
► Unscrew union nut [5-2] fully.
► Release spindle lock [5-1].
► Remove union nut together with the clamp­
ing collet [5-3] from the spindle. Never
separate the union nut and clamping col­
let! They form one unit.
► Insert another clamping collet with union
nut into the spindle.
► Gently turn union nut. Do not tighten union
nut if there is no cutter inserted!
5
5-1
1
2
3
8.5 Setting the routing depth
► Slacken locking mechanisms for routing
depth [1-3] + [1-6].
► Adjust desired routing depth at the routing
depth setting [1-7].
► Secure locking mechanisms for routing
depth [1-3] + [1-6].
8.6 Dust extraction
WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
5-2
5-3