Lumel PD9 Service Manual

en
of rs-485/ ethernet interface
service manuaL
full version of user's manual
available at www.lumel.com.pl
1. Hardware inSTaLLaTion
• use a standard ethernet cable to connect the Pd9
to an ethernet router or connect it directly to a Pc.
• rS-485 can connect with a Pc or other serial port device
by serial cables.
2. communicaTion inTerfaceS
converter
PD9
rS-485/rS-232 Terminal Port (G, B/r, a/T)
Pin Definition
1 Power interface
2 rS485/rS232
quicK start
Terminal
3 Lan Port
3. SofTware inSTaLLaTion
• Setup software Pd9config available for download from the website
www.lumel.com.pl
4. confiGure Pd9 Via weB PaGe
• assign a static iP address to your computer in the 192.168.0.2
to 192.168.0.254 range.
mask 255.255.255.0. This is necessary to ensure that your com-
puter can communicate with Pd9 converter.
• The default IP address is 192.168.0.7 open your web browser
and enter this iP to connect with Pd9 for configure.
Description
Power supply: 5-36V dc wiring
needs to check marks '+' "-"
Based on the photo,from right to left
is G, B/r, a/T
rJ45 socket
Default Parameters
user name admin
Password admin
iP address 192.168.0.7
mask 255.255.255.0
Gateway 192.168.0.1
work mode TcP client
Local Port 0
Baud rate 115200 bit/s
Target Port 8234
Target iP 192.168.0.201
Parity bit/data bit/Stop bit none/8/1
LUMEL S.A.
ul. słubicka 4, 65-127 zielona Góra, Poland
tel.: +48 68 45 75 100, fax +48 68 45 75 508
www.lumel.com.pl
Technical support:
tel.: (+48 68) 45 75 143, 45 75 141, 45 75 144, 45 75 140
e-mail: export@lumel.com.pl
Export department:
tel.: (+48 68) 45 75 130, 45 75 132
e-mail: export@lumel.com.pl
Calibration & Attestation:
e-mail: laboratorium@lumel.com.pl