Nobile 9109011009 Mounting And Operation Instructions page 2

Mounting-/
Operation Instruction
EN
Safe use of the product is only guaranteed if each instruction is followed accordingly. In case of damage caused by non-observance of these
instructions the warranty expires. The installation and electrical connection must be done by an authorized expert (e.g. electrician) in compliance
with existing standards and local code. Prior to any installation or maintenance work, mains must be disconnected. Before putting in operation,
make sure any component of the entire installation does not bear a risk of life. According to common practice, please perform a standard function
test, before installing. To make maintenance work possible, the lighting system should be accessible after installation (auditable).
Technical Specification
Transmission protocol
Operation Frequency
Transmission Power
BLE Range
Temperature measurement range
Humidity measurement range
Viewing angel
Ambient Temperature Ta
Mounting:
The device can be installed in 2 ways. 1) The device is equipped with a magnet inside, this allows mounting in any metallic surface or 2) by
using the provided adhesive tape.
Commissioning
To add the device in your nobile Smartmatic 2.0 App, select "Add Device". Press the button for 5 seconds until the LED starts blinking. The device
icon will appear in the nobile Smartmatic 2.0 App screen. Then select "Add", this will take from 10 seconds to 2 minutes depending on the signal
strength. Select "Next", you will see a "Added successfully" notification signifying that the device is now added in the app. Then lastly select "Done"
Controlling the Device:
The Smartmatic 2.0 App will create an hourly record of the measured temperature and the humidity.
Temperature/Humidity Sensor with Display BT
BLE 4.2
2.40 GHz
10 dBm
up to 90 meters in free field
-20 ~ 60°C ( 2°)
0 ~ 100RH ( 5%)
CR2 (3V)
-20 ~ 60°C
Blinking
LED
OFF
Reset or enter
configuration
mode
Button
Trigger to report
current status
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
For more specifications, please
refer to the data sheet of this
product.
The device enters BLE network configuration mode(preparing to
connect the gateway)
The device is under standby status
Press and hold the button for 5 seconds until the blue LED blinks,
the device will enter configuration mode
When the device is under standby status, press the button one time
and the device will report its current status to gateway.
rev. 0.0 – 08.04.2022
free to download
nobile Smartmatic 2.0 APP
on Google Play or Apple APP Store