ENGlIsH
or object during use. DO NOT suspend tool
overhead or suspend objects from the belt hook.
WARNING: To reduce the risk of serious personal
injury, ensure the screw holding the belt hook is
secure.
IMpoRTaNT: When attaching or replacing the belt
9
10
hook
, use only the screw
securely tighten the screw.
9
The belt hook
can be be attached to either side of the
10
tool using only the screw
left- or right- handed users. If the hook is not desired at all, it
can be removed from the tool.
To move belt hook, remove the screw
belt hook in place then reassemble on the opposite side. Be
sure to securely tighten the screw.
Anvils (Fig. C, D)
WARNING: Use only impact accessories. Non-impact
accessories may break and cause a hazardous
condition. Inspect accessories prior to use to ensure
that it con tains no cracks.
CAUTION: Inspect anvils, detent pins and hog rings
prior to use. Missing or damaged items should be
replaced before use.
Place the switch in the locked off (center) position or
remove battery pack before changing accessories.
Anvil with Detent Pin (Fig. C)
DCF894
To install an accessory on the anvil, align the hole in the
side of the accessory with the detent pin
Press the accessory on until the detent pin engages in the
hole. Depression of detent pin may be necessary to aid
installation of accessory.
To remove an accessory, depress the detent pin through
the hole and pull the accessory off.
Fig. C
11
3
Anvil with Hog Ring (Fig. D)
DCF894H
To install an accessory on the hog ring anvil, firmly push
3
accessory onto the anvil
. The hog ring
allow the accessory to slide on. After accessory is installed,
the hog ring applies pressure to help provide
accessory retention.
32
that is provided. Be sure to
provided, to accommodate
10
that holds the
11
on the anvil
DCF894
12
compresses to
Fig. D
12
To remove an accessory, grasp the accessory and firmly
pull it off.
NoTE: The thru-hole (Fig. D) allows an O-ring with retaining
pin or a 1-piece retaining pin to be used to help secure
sockets and accessories to the tool.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. E)
NoTE: For best results, make sure your battery pack is
fully charged.
3
.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
5
button
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual
Fig. E
3
DCF894H
6
into the tool handle, align the