Troubleshooting; Blending Tips - Hamilton Beach 50233H User Manual

840164500 ENnv09.qxd 8/23/07

Troubleshooting

PROBLEM
Blender leaks.
Does not blend well.
Cannot remove base.

Blending Tips

Crushing Ice
For best performance, when a recipe calls for liquid, place the liquid in blender jar followed by the ice cubes. Ensure ice cubes are
separated. When only crushed ice is desired, add 1 cup (250 ml) of ice cubes to jar. Place lid on blender jar then Pulse on any of the
5 pulse speeds. Allow blades to come to a complete stop between pulses. Continue until ice is crushed to desired consistency.
For best results always crush ice immediately after removing from freezer.
General
To add foods when blender is operating, remove filler cap from container lid and add ingredients through the opening.
Do not store food or liquids in the blender jar.
10
3:25 PM Page 10
PROBABLE CAUSE/SOLUTION
• Tighten collar on jar.
• Make sure lid with filler cap is pushed down tightly on jar.
• For units with separate gasket, make sure gasket is in place on cutter assembly.
• Make sure enough liquid has been added. A minimum of 8 ounces (250 ml)
is recommended.
• Do not try to mash potatoes, mix stiff dough, whip egg whites, grind raw meat, or
extract juices from fruits and vegetables. The blender is not made to perform these tasks.
• If mixture is too thick, continue to add liquid until mixture is blended to desired consistency.
• Loosen collar by holding jar and turning collar counterclockwise.