Advertisement
Quick Links
Assembly Instructions
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
(1) 0167429
Worksurface
(2) 0167674
Side panel
(2) 0167428
Leg
(4) 0190604
3" Twin wheel locking
stem caster
1/2-13 x 1"
Assembly tip: Do not tighten component fasteners completely
until all have been installed. Keeping them loose will help with
alignment between parts during assembly.
(2) 0167671
Frame
Parts Bag
(2) 0169174
Catch
Companion Equipment Rack
55559
(2) Door assembly
(one acrylic, one
laminate panel)
(1) 0119468
Recessed
bumper
(8) 0106543
1/4-20 Keps nut
3
/
"
4
(1) 0169077
Bottom panel
(48) 0190174
#8 x 3/8" PHSM
(4) 0101382
#14 x 7/8" PHSM
0193055 Page 1 of 5
Advertisement
Summary of Contents for Spectrum 55559
- Page 1 Any parts damaged during shipment must be reported within 5 days of receipt. To report information regarding missing parts or damage, to purchase parts or accessories, or if you have any questions, please contact us. www.spectrumfurniture.com 800-235-1262, 715-723-6750 Thank you for purchasing Spectrum products! Companion Equipment Rack 55559 (1) 0167429 Worksurface ”...
- Page 2 Attach frames to worksurface Frame Frame with rack rails 1. Place the worksurface face-down onto a non-abrasive surface. 2. The frame with the assembled rack rails will go on the concave side of the worksurface. The frame without the rails goes on the convex side. 3.
-
Page 3: Attach Side Panels
Attach side panels 1. Align each side panel as shown and secure with (17) #8 x 3/8” PHSM screws. Figure 3. 2. Repeat on second side panel. Note: Attach (2) recessed bumpers using the upper and lower holes on the right side of the panel as shown. #8 x 3/8”... -
Page 4: Attach Legs
Attach legs 1. Insert leg tabs into side panel slots. Figure 4. 2. Secure each leg with the (4) threaded studs and (4) 1/4-20 Keps nuts and tighten securely. Slots 1/4-20 1/4-20 Keps nut Keps nut Figure 4 Install casters Flip rack box upright 1. - Page 5 #8 x 3/8” PHSM Figure 8 1500 RIVER STREET, PO BOX 400, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM © 2022 Spectrum Industries Inc., All rights reserved. 0193055 Page 5 of 5...