Tesla TI4200 GPU-24 User Manual page 35

6
Troubleshooting & FAQ
Fault
7. Circuit breaker continuously
trips
8. Unit does not put out 28.5
volts dc power.
9. Unit stand alone voltage is
less than 23 volts.
10. Unit weakens after fi rst
start.
Troubleshooting for the Pure Sine-Wave Inverter is continued on the next page.
28
Possible Cause
A. Unit is overheating.
A. Unit is not plugged in.
A. Cells discharged.
A. Weak cells.
Remedy
A. Disconnect unit from ac input and dc
output.
B. Switch breaker to ON position.
Reconnect unit to cables and run.
C.
D. If LEDs still do not illuminate, Please
contact Tesla™ Customer Service at
(302) 324-8910.
A. Plug unit into ac power source to
maintain 28.5.
B. Stand alone Vdc is 24 Volts
(unplugged).
A. Plug unit into ac power source.
B. Recheck capacity after 25 minutes.
Failure to hold above 23 Vdc, Please
C.
contact Tesla™ Customer Service at
(302) 324-8910.
A. Allow between 30 to 60 seconds
backcharge between uses.
TI4200 GPU-24