Regulated 28.5 Vdc Ground Power - Tesla TI4200 GPU-24 User Manual

3.11 – Regulated 28.5 Vdc Ground Power
Connecting DC Power Cable To Unit
Ensure dc power cable plug is fully seated into the GPU's DC Battery Receptacle. Attaching a dc plug is
quick and easy. Line up the plug with the receptacle. Push forward while rotating the T-handle one full turn
clockwise. The unit is now ready to safely transfer power.
Connecting DC Power Cable To Vehicle or Aircraft
Line up the NATO plug or aviation dc plug pins and push it in. DC bus power should come on and aircraft
voltmeter should indicate 24 Vdc to 23.5 Vdc (23 Vdc minimum). Ensure dc power cable plug is fully seated
into the vehicle or aircraft's dc receptacle.
Figure 3.11.2 Attaching NATO DC Power Cable
Low Power Demand
Low power demand is defined by a requirement of 200 amps or less. Connect dc power to aircraft ground
power receptacle. DC bus power should come on and aircraft voltmeter should indicate 28.5 Vdc to 27 Vdc
(26.5 Vdc minimum). If aircraft power demand is less than 200 amps converter output will remain at 28.5
Vdc (only one GREEN LED status indicator bar will illuminate). If aircraft power demand exceeds 200 amps
converter voltage output will decrease and two or more LED status indicator bars will illuminate.
TI4200 GPU-24
Figure 3.11.1 Attaching DC Power Cable to TI4200 GPU-24
to vehicle
Operating Procedures
Figure 3.11.3 Attaching an Aviation DC Power
Cable to aircraft
3
15