Advertisement
COMMERCIAL
Natural Water Treatment System
PZ2-8 Skid Mount System -
Ozone Generator Systems
Prozone Water Products: 3004 11th Ave. - Huntsville, AL - 35805 Phone: 256-539-4570 Website: www.prozoneint.com
Commercial Pools
INSTALLATION GUIDE and
OPERATION MANUAL
T . O
NATURAL TECHNOLOGY
3
Reduces Chemical Usage,
Improves Sanitation
Produces Crystal Clear Water
Copyright 2010
Advertisement
Table of Contents
Related Manuals for Prozone PZ2-8
Summary of Contents for Prozone PZ2-8
- Page 1 Commercial Pools INSTALLATION GUIDE and Ozone Generator Systems OPERATION MANUAL T . O NATURAL TECHNOLOGY Reduces Chemical Usage, Improves Sanitation Produces Crystal Clear Water Copyright 2010 Prozone Water Products: 3004 11th Ave. - Huntsville, AL - 35805 Phone: 256-539-4570 Website: www.prozoneint.com...
-
Page 2: Important Safety Instructions
Wear safety glasses when drilling and/or tapping holes for installation of system. PZ2-8 Skid Mount System should be securely bolted or fastened down to a flat level surface. WARNING: Short term inhalation of high concentrations of ozone and long term inhalation of low concentrations of ozone can cause serious harmful physiological effects. -
Page 3: Introduction To Ozone
The two halfs may be unbolted and placed side-by-side if desired, requiring less floor space depth but doubling floor space width. A flat level surface is required for placement of the PZ2-8 Skid Mount System. Minimum of 48” by 40” for back-to-back placement or 90” by 20” for side-by-side placement. -
Page 4: Installation
The PZ2-8 System is to be installed as a bypass system with the entrance of the bypass being after the main pool circulation pump but before the filter, and the exit of the bypass being after the filter/heater. -
Page 5: Operation
OPERATION Turn on PZ2-8 Boost Pump, (top breaker), and allow water to fill the PZ2-8 plumbing and begin to flow completely through the system. Close the Ball Valve, in between the Venturi Injector(s), by rotating it clockwise fully and allow the system fo run for a minute or two to stabilize.
Need help?
Do you have a question about the PZ2-8 and is the answer not in the manual?
Questions and answers