Removing The Ignition Armature; Installing The Ignition Armature; Combination Switch - Makita EA6100P Repair Manual

07 IGNITION SYSTEM
5
1

Removing the ignition armature

Remove the cover.
Remove the starter. See Chap. 06.
Remove the  ywheel. See Chap. 07.
Unscrew 2 bolts on ignition armature 1.
Pull off cable lug 2 .
Unscrew bolt 3 and remove with cooling air
guide.
Unscrew bolt 4 and remove with cable clamp.
Remove ignition armature with high-voltage
cable, carefully pulling cable lug 2 through the
rubber grommet on the carburettor  oor.

Installing the ignition armature

NOTE: The high-voltage cable is moulded
onto the ignition system and cannot be
replaced separately.
Insert the ignition armature and screw in the
screws until just before they stop.
Repair Manual EA6100P / EA6101P
2
3
4
Secure the high-voltage cable under the cable
clamp with bolt 4.
Carefully push cable lug 2 through the rubber
grommet on the carburettor  oor.
Note: Make sure not to press the rubber
grommet into the carburettor when doing this.
If the grommet gets pushed out, it can be
reinserted from the cylinder side.
Route the high-voltage cable as shown,
engage the cooling air guide tab 5 and secure
it with bolt 3.
Install the  ywheel.
Insert the setting gauge 6 (chap. 00, Pos. 3)
between the ignition armature and the fylwheel.
Position the  ywheel so that the magnet is
against the armature (gap 0.25 –– 0.3 mm).
6
Press the armature against the gauge towards
the  ywheel and tighten the armature screws
(5 Nm). Then check the gap again to
+/-0.5
make sure it is correct.

Combination switch

7
10 9
Remove the cover and air  lter. Pull off cable
lug 2.
Unscrew 4  anged nuts 8 (A/F 7).
Unscrew bolts 7.
Carefully remove the air  lter base from the
rubber buffers 9 and disengage the choke
linkage (arrow).
The combination switch 10 with ground wire
and contact spring can now be removed from
the air  lter base.
Note: If the gasket on the carburetor or air  ap
is damaged, it must be replaced.
Assemble in reverse order.
8
18