Electrical Adjustment - Sony SS-TS500 Service Manual

HCD-S500/S800
In making adjustment, refer to 5-2. Adjustment
Related Parts Arrangement.
Note: During diagnostic check, the characters and color bars can
be seen only with the NTSC monitor. Therefore, for
diagnostic check, use the monitor that supports both NTSC
and PAL modes
This section describes procedures and instructions necessary for
adjusting electrical circuits in this set.
Instruments required:
1) Color monitor TV
2) Oscilloscope 1 or 2 phenomena, band width over 100 MHz,
with delay mode
3) Frequency counter (over 8 digits)
4) Digital voltmeter
5) Standard commander
* RM-SS800 (1-418-838-11)
6) DVD reference disc
HLX-501 (J-6090-071-A) (dual layer)
HLX-503 (J-6090-069-A) (single layer)
HLX-504 (J-6090-088-A) (single layer)
HLX-505 (J-6090-089-A) (dual layer)
7) SACD reference disc
HLXA-509 (J-6090-090-A)
* Use only the designated remote control when adjusting this
system component.
22
SECTION 5

ELECTRICAL ADJUSTMENT

5-1. ADJUSTMENT OF VIDEO SYSTEM
1. Video Level Adjustment (DVD BOARD)
<Purpose>
This adjustment is made to satisfy the NTSC standard, and if not
adjusted correctly, the brightness will be too large or small.
Mode
Signal
Test point
Instrument
Adjusting element
Specification
Adjusting method:
1) In the test mode initial menu "6" Video Level Adjustment, set
2) Adjust the RV501 to attain 1.0 ± 0.02 Vp-p.
2. S-terminal Output Check
<Purpose>
Check S-terminal video output. If it is incorrect, pictures will not
be displayed correctly in spite of connection to the TV with a S-
terminal cable.
Mode
Signal
Test point
Instrument
Specification
Checking method:
1) In the test mode initial menu "6" Video Level Adjustment, set
2) Confirm that the S-Y level is 1.0 ± 0.1 Vp-p.
Video level adjustment in test mode
Color bars
MONITOR OUT (VIDEO) connector
(75 Ω terminated)
Oscilloscope
RV501
1.0 ± 0.02 Vp-p
so that color bars are generated.
Figure 5-1
Video level adjustment in test mode
Color bars
S VIDEO OUT (S-Y) connector
(75 Ω terminated)
Oscilloscope
1.0 ± 0.1 Vp-p
so that color bars are generated.
Figure 5-2
1.0 ± 0.02 Vp-p
1.0 ± 0.1 Vp-p