Table of Contents
Advertisement
Screw the appliance onto the mounting brackets.
4.
Align the appliance and the mounting brackets in
5.
the cabinet and tighten all of the screws.
Secure the exhaust pipe to the air pipe connector.
6.
Connect the exhaust pipe to the exhaust air opening
7.
on the external air extraction system.
Seal the joints.
8.
Insert the mains plug into the protective contact
9.
socket.
Fit the grease filters.
10.
To avoid causing damage, do not bend the grease
filters.
Changing the filter pull-out's limit stop
Pull out the filter pull-out fully.
1.
Undo the screw for the front end stop and pull it for-
2.
wards as far as possible.
Close the filter pull-out and align it to the furniture.
3.
Pull out the filter pull-out again.
4.
Retighten the screw for the front end stop.
5.
Setting the air flow
Requirement: The grease filters have been removed.
→ "Removing the grease filter", Page 7
To set the air flow, change the position of the ab-
1.
sorber.
In order to increase the air flow, open the one-way
2.
flap and remove the reducing disc.
Adjust the reducing disc.
3.
Insert the reducing disc and close the one-way flap.
4.
Measuring the airflow
In order to measure the pressure drop, attach the
▶
hose to the measurement opening
edge of the air pipe connector.
Installation instructions en
on the front
13
Advertisement
Table of Contents
