Before First Use; Daily Use - Washing Only - AEG L7WBG851R User Manual

The appliance keeps the selection of this
option after you switch it off.
10.3 Acoustic signals
The acoustic signals operate when the
programme is completed (sequence of
sounds for about 2 minutes).
To deactivate/activate the acoustic
signals, touch the Stains/Prewash and
the Delay Start buttons simultaneously
for about 6 seconds.
If you deactivate the
acoustic signals, they
continue operate when the
appliance has a malfunction.
10.4 Permanent Extra Rinse
With this option you can permanently
have one or two extra rinses when you
set a new programme.

11. BEFORE FIRST USE

During installation or before
first use you may observe
some water in the appliance.
This is a residual water left
in the appliance after a full
functional test in the factory
to ensure the appliance is
delivered to customers in
perfect working order and is
no cause for concern.
1. Make sure that all transit bolts have
been removed from the appliance.
2. Make sure that the electrical power is
available and the water tap is open.

12. DAILY USE - WASHING ONLY

WARNING!
Refer to Safety chapters.
12.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
• Simultaneously touch the
Temperature button and the Spin
button once to add one extra rinse.
appears on the display.
• Simultaneously touch the
Temperature button and the Spin
button twice to add two extra rinses.
appears on the display.
• Simultaneously touch the
Temperature button and the Spin
button three times to remove extra
rinses. The display only shows
3. Pour 2 litres of water into the
detergent compartment marked by
.
This action activates the drain system.
4. Pour a small quantity of detergent
into the compartment marked by
5. Set and start a programme for cotton
at the highest temperature without
any laundry in the drum.
This removes all possible dirt from the
drum and the tub.
3. Press the On/Off button for a few
seconds to activate the appliance.
The indicator of the Start/Pause
button starts flashing.
The programme dial is automatically set
on default programme and only the
indicator Wash is on above the Mode
button.
ENGLISH 27
.
.